Browsed by
Month: February 2017

How to Fix a Leaky Drain

How to Fix a Leaky Drain

this article was written by Jeffrey Bigg from A1 Water

Eventually, chances are good you, as a homeowner, will have a leaky drain when that happens you don’t always have to search for an emergency plumber¬†you might be able to fix it yourself. A drain will usually commence to leak when it is a few years old. After several years, the putty will dry out, the links can become loose, or the pipes will get started to crack. Awkward, having a good understanding of how to fix a leaking drain is important and will help you fix leaks before they cause even more damage.

Stage 1- Disassemble Drain
The first step in correcting a leaky drain is determine where the outflow is originating. If you have determined that the leak is from the drain itself, then get started to disassemble the drain by by using a plumber‘s wrench tool. Remove all the snare fittings that you can unscrew without by using a tool. For some of the traps you will need to use an electric screwdriver to take out fittings.

Loosen the tail piece of the drain with an changeable pipe wrench and remove it from the drain. Remove the plastic that retainers and take off the drain pipe.

Step 2- Clean All Pieces
When you have take the complete drain assembly apart, then you will need to clean each piece extensively. Set each piece in a bucket of warm water and soap. You may even need to use some baking soda or vinegar to remove some of the caked-on putty and inside corrosion. Permit the pieces soak to loosen up the hard debris before you try to scrub it off. Pay attention to the putty that is still left on the connections. If perhaps there is any putty left on the part left when you commence to install it, it can interfere with the new putty and cause another leak.
Step 3- Reassemble Drain
After everything has been cleaned off and dried completely, you can get started to reinstall the drain. For each interconnection that you have, apply a thick coating of plumber’s putty. Apply a 1/2 inch layer throughout the drain pipe. Lower the drain pipe back into the drain and reattach the pipe to the fittings underneath the drain. Put together the tailpipe and traps and ensure all connections are limited. Once everything is again together, turn the drinking water on and allow it run for a little while to evaluate for any more leaks. If you locate any, it might be because the putty was not applied effectively or the contacts are too tight.

Stage 4- Do Not Over-tighten
It is hard to believe an association that is too tight actually will lead to more leakages. However, due to compression surrounding the pipe, when you over-tighten the connection it warps the pipe and the threads, and will allow for water to supply it. To fix the problem, take your flexible pliers and loosen the connection a little little bit. In case the leak gets more serious, then there is another problem. Try not to be surprised to see the leak stop. Remove off any excess putty or water, and look for more leaks.